Progress PV006-30 1100 Watt Heater/Bath Exhaust Fan/Light, 70 CFM

Progress PV006 1100 Watt Heater/Bath Exhaust Fan/Light, 70 CFM

• One piece white polymeric plastic
• Two louvered areas are divided by the lamp diffuser, one side is for heater, the other for the vent
• Single center mount to housing
• Dimensions - 12” wide, 17” long, 2” deep (Including diffuser)
• White polycarbonate
• Snaps into Trim/Grille
• Mounts to ceiling joists, or in a suspended ceiling
• Can be mounted in sloped ceilings up to a 12/12 pitch
• Galvanized steel
• 26 gage
• Mounting brackets with keyhole slots, and holes for ceiling wires
• Removable wiring cover for easy connections
• Internal wiring plate allows either top or side hole for conduit or BX fitter
• No KO's to remove
• Tapered sleeve polymeric 4” round duct fitting for positive connection
• Quiet polymeric damper to prevent cold backdrafts with no metallic clatter
• 120 volt, 1.15 amp, permanently lubricated
• Plug in for ease of servicing
• Snaps in or out for ease of cleaning and servicing - no screws
• Specially designed polymeric blower wheel
• 1100 watt nickel chrome resistance heater
• The heater is a plug in modular unit for ease of replacement if necessary.
• The fan motor is an open C frame configuration with a five blade fan
• The heater is mounted in a separate housing at one end of the main housing
• 100 watt lamp
• Medium based socket
• UL-CUL listed. Also listed for use over bathtubs and showers when connected to a GFCI protected branch circuit
• UL listed for use in insulated ceilings (IC listing)
• Air and Sound ratings are certified by HVI